Brand
Products
- Adhesives & Sealants
- Air Tools & Fittings
- Bearings
- Driveline
- Fasteners
- Filtration
- Fluid Power Fittings & Accessories
- General Engineering & Hardware
- Hand Tools
- Hose & Tube
- Hydraulic Control
- Lifting
- Lubricants
- Power Transmission
- Maintenance & Lubrication
- Plastic
- Welding, Brazing, Soldering
- Seals
- Power, Cutting Tools & Abrasives
- Safety
- Storage & Material Handling
Services
31 Oct 2017
To partner our customers to achieve optimum plant reliability through the application of knowledge and technologies which deliver the highest level of service and results.
Vibration Analysis
31 Oct 2017
This is the predominant technology employed in condition monitoring to determine the condition of various mechanical components and hence be able to make a prediction on service life expectancy and urgency of repairs.
Training
31 Oct 2017
Through a continuous commitment to quality BSC strives to provide solutions for industry.
Specialist Installation Services
31 Oct 2017
Did you know that only 10% of bearings reach their design service life in the real world!
Predictive Maintenance
31 Oct 2017
For Asset Optimization.
Predictive maintenance PdM aims to find measures of machinery condition and use them to prevent breakdowns. Establishing trends allow accurate pinpointing of machinery problems and their severity. Increasing up time on machines is the primary aim, while reduced likelihood of secondary failures and less unnecessary maintenance are additional benefits.
Oil Analysis
31 Oct 2017
Oil analysis is a cost effective method for determining the condition of existing lubricants and hence, predicting remaining service life.
Mechanical Equipment Refurbishment Service
31 Oct 2017
BSC Engineering Services can provide bearing refurbishment services which could save you thousands compared to a new bearing, particularly if lead times are longer than required for large or specialized bearings.
Laser Alignment
31 Oct 2017
Mis-alignment in mechanical systems such as motor/pump assemblies is a major factor in increased wear and premature failures.
Balancing
31 Oct 2017
Unbalanced fans, pumps and rotors place undue stresses and additional loads on bearings, motors and couplings substantially reducing component service life, and potentially causing a catastrophic failure which can damage surrounding equipment and harm employees.
Consulting and Design
31 Oct 2017
BSC can provide engineering consulting services for upgrades and new equipment designs.
Energy Audit Service
31 Oct 2017
Energy consumption can be reduced up to 40% by analysing inefficient and poorly designed drives and adopting good drive design practices.
Infrared Thermography
31 Oct 2017
Using a camera designed to capture heat energy in the infra-red (IR) spectrum, abnormal temperature conditions in machines and electrical devices can be identified.
Stop Leak
31 October, 2017
Air leaks are one of the biggest contributors to needless costs in any industrial plant/facility.
Stop Leak
Air leaks are one of the biggest contributors to needless costs in any industrial plant/facility.
A leak is a costly drain on overall operating costs. State-of-the-art ultrasonic equipment is used to identify air leaks.
The “Stop Leak” Process is the first step in continuous improvement. Every identifiable leak, including fittings, valves, flanges and hoses are tagged with a number, its location, severity and cost. From this, total estimated savings are generated within a corresponding report. The report provides a detailed format for a targeted approach and allows monitoring of progress by cfm and dollars saved.
Objectives of Operation Stop Leak
- Identify Air and Fluid Leaks
- Reduce energy usage
- Reduce fluid loss
- Identify Cost Savings
- Energy savings translate into cost savings
- Reduce cleanup costs
- Increase Safety & Reliability
- Identifying air and fluid leaks enable corrective action to be implemented
- Training in use of Loctite solutions reduces rework and improves equipment reliability
Took 0 milliseconds